youtube threading a brother project runway sewing machine

Youtube threading a brother project runway sewing machine how to#

These threads are thinner than wool and polyester threads, so care should be taken when using them so as not to create any holes in your project. If your project involves lots of detail, then you would also want to consider the thickness of the thread.įor delicate or lightweight fabrics, cotton or novelty threads can be used. Thread weight is measured in tex, with eight being the heaviest and 50 being the lightest. If you are doing a lot of topstitching, you might want to use a heavier thread. This question should be answered by first considering what you’re sewing. What Is The Best Thread For Brother Sewing Machine? Work the needle from front to back until about two inches of thread left. Before removing the disc, pull both threads on either side of it to remove any slack, then lift up and down until you reach the take-up lever. Guide the thread through the tension disc. The thread should be down the correct groove at the front of the LS 2125. Place the spool of thread on its pin and feed the thread through the thread guide. Raise the foot lever and turn the handwheel to raise the needle to its highest position. The first thing is to turn off the sewing machine.

Youtube threading a brother project runway sewing machine how to#

How To Thread A Brother LS 2125 Sewing Machine? How To Thread The Brother Sewing Machine Video Tutorial?Įnjoy this video tutorial to visually guide you through the steps of how to thread the brother sewing machine. Now that we have both ends tied, you can turn your sewing machine on and get to work. Just like before, bring it back down through those same two loops and do this with both ends of your bobbin thread and then tie a knot and cut off any excess thread. Once your thread is through, you will want to take one end and go under those same two loops we did earlier with our needle thread. Once you have pulled, grab both ends by pinching them together with one hand over the other again, and make sure you grab it close to the holes and not closer to the spool. You will want to leave about two inches or so of thread under your spool before you pull. Now it’s time to take that bobbin thread and run it through the little slot on the top of your machine. Place it accordingly by pushing it down with a little screwdriver or something similar until it is secure. Make sure you set your bobbin, so the thread comes off on the bottom of your sewing machine and not on top of your bobbin case. Take one end and go under both loops on top of your machine, bring it back down through those same two loops, repeat with your other hand, and then tie a knot and cut off any excess thread. Pull the ends of the thread up and hold them in each hand with one hand over the other.

Put your thumb on top as you do this so as not to put your fingers in as well accidentally. Now it’s time to take the thread from underneath the spool and put it through one of those little holes on top of your machine. Next, you will want to raise the needle and pull it to the right for a second before you continue. First, turn the sewing machine off and lift the presser foot. It’s A Wrap! How To Thread The Brother Sewing Machineįollow the guide below to know how to thread a Brother sewing machine: